Subsystems Lead Jobs in Abu Dhabi, UAE

Key Responsibilities

1. Subsystem Architecture & Technical Ownership

Define and own the electrical and control subsystem architecture for micro-turbojet and turbofan engines.
Establish functional, performance, environmental, and interface requirements for:
- Engine Control Units (hardware and firmware)
- Engine control software (closed-loop fuel, EGT, RPM, and protection logic)
- High-speed electric generators and associated power electronics
- Fuel pumps, solenoids, and electrically actuated valves
Ensure subsystem designs are aligned with engine-level performance, safety, reliability, and integration targets.

2. ECU & Control Software Leadership

Lead ECU hardware development, including:
- Processor and architecture selection
- Power conditioning and distribution
- Sensor and actuator interfaces
- EMI/EMC mitigation strategy
- Environmental robustness (thermal, vibration, humidity)
Oversee engine control software development, including:
- Start logic and sequencing
- Acceleration and deceleration schedules
- Protection logic, fault detection, and safe shutdown strategies
- Support for calibration, testing, and data logging
Ensure alignment with applicable aerospace, defense, and industrial standards.

3. Electrification & Actuation Systems

Lead the development and integration of:
- High-speed electric generators and rectification/regulation electronics
- Electric or hybrid fuel pumps, solenoids, and driver electronics
Define and manage performance envelopes for:
- Voltage, current, speed, efficiency, and thermal limits
Ensure compatibility of electrical subsystems with engine start systems and ground support equipment.

4. Make / Buy Strategy & Supplier Management

Develop and own make/buy decisions for all electrical and electronic subsystems.
Lead technical evaluation, selection, and oversight of:
- External design houses
- Electronics manufacturers
- Component and subsystem suppliers
Act as the technical authority for:
- Supplier Statements of Work (SOWs)
- Technical deliverables and reviews
Ensure suppliers meet cost, schedule, performance, and quality expectations.

5. Intercompany & External Contract Management

Manage technical scope and deliverables for:
- Intercompany development agreements
- External service providers and vendors
Review and approve:
- Technical documentation
- Design reviews (PDR, CDR)
- Verification and validation plans
Serve as the primary technical interface between Powertech Microjets and external partners for all electrical and control subsystems.

6. Integration, Test & Industrialization Support

Support subsystem integration into engine test articles and production engines.
Define and support:
- Subsystem-level test plans
- ECU and electrical system validation procedures
- Fault reproduction, troubleshooting, and root-cause analysis
Ensure designs are scalable to rate production, with clear paths for cost reduction and supply chain robustness.

Required Qualifications & Experience

Bachelor’s or Master’s degree in:
- Electrical Engineering
- Mechatronics
- Control Systems
- Aerospace Engineering (with strong electrical focus)
3–5 years of relevant experience in a gas turbine development environment, with exposure to:
- Engine control systems
- Electrification or actuation subsystems
- Embedded or safety-critical control hardware
Demonstrated experience working in multi-disciplinary engineering teams.
Strong understanding of:
- Embedded hardware and firmware development
- Closed-loop control systems
- EMI/EMC and harsh-environment electronics
Experience in aerospace or defense programs is preferred.

Key Competencies

Authority & Accountability

Technical authority for all engine electrical and control subsystems within Microjets.
Final recommendation authority on subsystem architecture and supplier selection.
Accountable for subsystem technical readiness, integration success, and risk mitigation.

Subsystems Lead Full Time